''Making stuff… Simpler''
In my earlier tutorial, you learned how to import coordinates into CATIA V5 from Excel with the help of Macros. In this tutorial, we will see how to use one of the most important and popular command – Multi section solid, in CATIA and explore different options & modes of coupling in it.
more “Different modes in Multi section solid | CATIA V5 tutorial”
No matter what 3D modeling software you use there comes a time when you need to import points because of the complexity of a part or a curve.
And at times when you are new to the software or a beginner, you need help. So this article is for them who are in their rudimentary stages of software and need help on how to import airfoil coordinates from Excel to CATIA V5.
Hellloooo people, today we’ll be seeing what is a motor driver module, how to use it and where to use it – its connections and coding. So without wasting time, let’s directly jump to our motor driver L298N Arduino tutorial.
more “How to use motor driver L298N – Arduino tutorial”
So you wanna build a robot which never hits anything; you’ve come to the right place! It barely takes 15 minutes to do this! So without wasting our time let’s learn how to make an obstacle avoiding robot!
more “How to make obstacle avoiding robot using Arduino & Ultrasonic sensor ?”
At first, I had a notion that it must be such a difficult job – controlling things just by giving voice commands ! Uhh… it seemed that only the experts & nerds could do it ! But believe me, this turned out to be one of the easiest things I’ve come across related to Arduino. So without wasting our time lets know how to control LEDs with voice commands with this Arduino-Bluetooth module tutorial ! more “Control LEDs with Voice Command | Arduino-Bluetooth module tutorial”
You already know what we are gonna do today…so lets get started !
more “Control LEDs with your Android | Arduino-Bluetooth module tutorial”
Today I’m going to show you how to control any device with an Infrared remote(TV,DVD,AC etc.) and with the help of Arduino board. So lets get started.
Things you’ll need :-
Of Infrared reciever-
Pin 1 – GND (Ground pin of Arduino).
Pin 2/Middle pin – VCC (5v supply of Arduino).
Pin 3 – Data pin (pin number 3 on Arduino).
Note :- The pin no. 3 is a bit separated from the other two ! Don’t misunderstand between pin1 & pin3 !
#include <IRremote.h>
int RECV_PIN = 3; //declared for receiving pulses
int c=0; // declared if you want to control with a single button
IRrecv irrecv(RECV_PIN);
decode_results results;
void setup()
{
pinMode(9, OUTPUT);
Serial.begin(9600);
irrecv.enableIRIn(); // Start the receiver
}
void loop() {
if (irrecv.decode(&results)) {
Serial.println(results.value);
irrecv.resume(); // Receive the next value
if(results.value==YOUR VALUE1)
{
digitalWrite(9,HIGH);
}
else if(results.value==YOUR VALUE2)
{
digitalWrite(9,LOW);
}
}
}
/* if((results.value== YOUR VALUE3)&&(c%2==1)) // enables you to turn on & off with the help of same button"
{
digitalWrite(9,HIGH);
}
else if((results.value==YOUR VALUE3)&&(c%2==0))
{
digitalWrite(9,LOW);
}
c++;
}}*/
Here’s a video tutorial which will definitely make things easier for you 😉
Please comment below if you face any difficulties. I’d love to solve them 🙂 .